Crestron HD-RX3-C-B 4K HDMI Receiver (Black)

Crestron HD-RX3-C-B 4K HDMI Receiver (Black)

The Crestron HD-RX3-C 4K HDMI over HDBaseT Receiver delivers a professional digital HD AV signal extension solution for use in homes, classrooms, auditoriums, or corporate boardrooms. Without any special setup or configuration, the HD-RX3-C connects directly to an HDBaseT source, enabling the transmission of ultra high-definition digital video and audio over wire runs up to 330 feet (100 meters) using a single CAT type twisted pair cable.[1]

Features:

• HDBaseT® Certified 4K Ultra HD signal extender
• Extends uncompressed digital video and audio over a single CAT type twisted pair cable [1]
• Supports cable lengths up to 330 ft (100 m) for all resolutions up to 4K and Ultra HD using DM® Ultra cable [1]
• Supports cable lengths up to 330 ft (100 m) for 1080p, WUXGA, and 2K using DM 8G® cable or CAT5e [1]
• Supports cable lengths up to 230 ft (70 m) for 4K and UHD using DM 8G cable, or 165 ft (50 m) using CAT5e [1]
• Compatible with HDBaseT sources [3]
• Compatible with HDMI® and DVI display devices [4]
• Supports Dolby® TrueHD, DTS-HD®, and uncompressed 7.1 linear PCM audio
• HDCP compliant
• Passes CEC and EDID
• Enables IR and RS-232 signal extension when paired with an HD-TX3-C [2,3]
• 24VDC power pack included
• No programming or configuration required

Notes:

1. The maximum cable length for HDBaseT is dependent upon the type of cable and resolution of the video signal. Refer to the “Maximum HDBaseT Cable Lengths” table for a detailed overview. Shielded cable and connectors are recommended to safeguard against unpredictable environmental electrical noise which may impact performance at resolutions above 1080p. All wire and cables are sold separately.
2. HD-TX3-C sold separately or as part of the HD-EXT3-C 4K HDMI® over HDBaseT Extender package.
3. IR and RS-232 control signals are only supported when paired with an HD-TX3-C transmitter.
4. HDMI requires an appropriate adapter or interface cable to accommodate a DVI signal. CBL-HD-DVI interface cables are available separately.
5. When the HD-RX3-C receiver is connected to a HD-TX3-C transmitter, only one power pack should be connected to either the receiver or the transmitter, not both. Power is passed to the secondary device via the HDBaseT connection. Please note, the HD-RX3-C and HD-TX3-C are not PoH compatible. They cannot be powered by, or supply power to, another HDBaseT device. They may however be connected to such devices without risk of malfunction.